Just built these for my Festool systainers and to reorganize a little. Took my last 2 sheets of prefinished ply and some scrap. Also drilled all the shelf pin holes with my 32 system so I can start installing some pull outs.



[ Specified attachment is not available ]



Lambeater.

thanks wish the images would stop rotating.

Lambeater

You'll certainly want to install the pullouts.  The tool you want next is always going to be at the bottom of a stack.

You'll certainly want to install the pullouts.  The tool you want next is always going to be at the bottom of a stack.

yes I will, already drilled for them.
lambeater

Curious why you put them so high. If you put the cabinet on the ground, then used SYS-AZ drawers, you could remove a tool without removing the systainer. I feel like I'm missing something.

yes I put them high because my shop is only 12ft wide in the main part so needed to utilize space and still be able to use table saw. seemed the best option.

Lambeater