Author Topic: Could this be the poor man's solution to the CT15 anti-static hose?  (Read 810 times)

0 Members and 1 Guest are viewing this topic.

Offline ChuckS

  • Posts: 3715
I observed that if I used the belt sander (40x/60x) to remove lots of material aggressively, a thick coat of dust could be seen on the front part of the hose. None if used with the PRO5 LTD (100x and above).

If I grounded the hose, would that make a difference? It seemed so (see the last image). There wasn't any layer of dust, just scattered dust particles on the hose. But further field tests/uses will be needed to see if this is actually something worth doing.

Test done with -

2x4 block: about 12 - 15mm surface material removed

Grounding kit:

« Last Edit: March 06, 2022, 01:02 PM by ChuckS »