Author Topic: Is there a way to fix a warped door?  (Read 2850 times)

0 Members and 1 Guest are viewing this topic.

Offline Alex

  • Posts: 7665
Re: Is there a way to fix a warped door?
« Reply #30 on: February 19, 2021, 10:11 AM »
Packard, it is a solid panel door, but with a layer of veneer glued on. Pictures are above. Turned out the door is not as badly warped as I first thought, but most of the problem is in the door jamb. I scribed the jamb to the door and cut a thin stripe away so the door sits flush again.


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.