Author Topic: How would you bandsaw this curved object (and why)?  (Read 476 times)

0 Members and 1 Guest are viewing this topic.

Offline ChuckM

  • Posts: 2631
How would you bandsaw this curved object (and why)?
« on: April 17, 2021, 02:36 PM »
A curved dish-like object is to be cut out from a 1-1/2" x 6" x 14" block. Would you go with method 1) or method 2)?

Method 1 - Cut out the shape B flat on the bandsaw, tape the cut-offs back, and then stand the block on its edge and saw out shape A.

Method 2 - Stand the block on its edge, cut out A, place the curved block concave side down on the bandsaw, and saw out shape B.

Or if you have another bandsaw approach.

Thanks.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Michael Kellough

  • Posts: 5198
Re: How would you bandsaw this curved object (and why)?
« Reply #1 on: April 17, 2021, 03:10 PM »
Method 2 plus.

After cutting out A tape the face (convex waste piece) back in original position and if needed tape on strips (on the flat side) to keep the package stable (on the band saw table) as perimeter is cut away.

Offline ChuckM

  • Posts: 2631
Re: How would you bandsaw this curved object (and why)?
« Reply #2 on: May 02, 2021, 12:23 PM »
Thanks for your response.

I did choose the safer method #2 (though my initial idea was to try both), and the outcome on all 6 pieces was great. To provide added stability, I clamped two blanks together before making the cut.

Now with the profile done, I'll proceed to do the outside shape.