Author Topic: UJK parf guide mk1 guestion  (Read 564 times)

0 Members and 1 Guest are viewing this topic.

Offline Paul Wells

  • Posts: 1
UJK parf guide mk1 guestion
« on: February 25, 2021, 03:05 PM »
Hi all,
I've just purchased the mk1 guide system, and noticed that the new rules, have both 3mm and 6mm holes for the drill guides, I assume, this so only need to produce one rule for both kits, also the guide pins seem to fe the same as used in the mk11, as is the 20mm jig,
My question is, as I've not had the chance to use this yet due to work commitments,and being away from the set, does anyone know if you can use these new rules to drill offset holes, using the 3mm hole positions. I havnt got any pictures of the new rules, but they have the 6mm holes and also a set of 3mm holes.
Thanks in advance.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Paulhoward

  • Posts: 5
Re: UJK parf guide mk1 guestion
« Reply #1 on: March 03, 2021, 10:01 PM »
I would like to know the answer, because I have the mark 1 system also have the mark 2 system. I would like to know if the sticks can be used for both systems?

Offline cubevandude

  • Posts: 107
Re: UJK parf guide mk1 guestion
« Reply #2 on: March 06, 2021, 05:08 PM »
Can you post some pictures please?

Offline imdking

  • Posts: 26
  • Tropical woodworking hobbyist
Re: UJK parf guide mk1 guestion
« Reply #3 on: May 14, 2021, 10:43 PM »
Please watch "New Brit workshop" videos on Parf guide system, then Parf guide mark ii. You'll then understand the differences between the two. Just searc on YouTube.
TS55 REBQ, FS 1400/2, FS 800, Festool carrying bag for rails, FS-AW Cable Deflector, Kapex KS 120 REB, CTM Midi, Domino DF 500, FS-HZ 160 ratchet lever clamps x2.