Author Topic: UJK Parf Guide Mark II drill bits info  (Read 780 times)

0 Members and 1 Guest are viewing this topic.

Offline Wood_Slice

  • Posts: 103
UJK Parf Guide Mark II drill bits info
« on: February 19, 2021, 05:29 PM »
Just wanted to post it out there in case anyone was wondering the size of the 3 mm drill bit. The length of the bit is longer than needed. I believe the common 60-62mm overall length might work fine for 3/4” material thickness.

The OG bit has the following writing on it

@3.0  GUHRING  HSS  19479371

The @ icon is a zero with a diagonal line representing mm i guess

  • Measured with a caliper and its dead on 3.0 mm diameter (imperial with caliper was 15/128”)
  • Overall length is 72 mm
  • Cutting flutes 40 mm length
  • Shaft 32 mm in length
  • Looks like 118 or 135 degree
  • HSS= high speed steel
  • GUHRING is the manufacturer brand
  • 19479371 is the item number identifying it (could not find it on their website or anywhere else)

SIDE NOTE- dogs that come with the parf guide mark 2 are
  • Overall height 22 mm
  • Bottom diamter 19.95 mm
  • top diameter 24.95mm
  • top height 10 mm
  • Bottom height 12 mm

« Last Edit: February 19, 2021, 06:50 PM by Wood_Slice »
DF 500 + Assortments | ETS EC 125/3 EQ | CT MIDI + CT-Fi| MFT3 + Elements| Installer's Set | TS55-REQ |

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Mike Goetzke

  • Posts: 894
Re: UJK Parf Guide Mark II drill bits info
« Reply #1 on: February 19, 2021, 05:56 PM »
"O" with diagonal through it usually represents diameter.

I'm pretty sure you can get spares for the Parf from TSO & Axminster.