« previous next »
Pages: [1]   Go Down

Author Topic: Amana Carbite Tipped Bits for Dominos  (Read 1180 times)

0 Members and 1 Guest are viewing this topic.

Offline Bruce W

  • Posts: 20
Amana Carbite Tipped Bits for Dominos
« on: January 07, 2022, 03:59 PM »
I recently ran across carbide-tipped bits for the Domino that are manufactured by Amana and sold through Toolstoday.com and I was wondering if any of you have ordered or had experience with these bits? They are quite a bit less expensive than Festool bits so I was considering purchasing some of them to try.  A few examples are shown below:

Amana Tool #316024  6mm bit $27
Amana Tool #316022  5mm bit $25
Amana Tool #316036  14mm bit $33

There are bits that are made for the Domino 500 and the Domino 700. 
On the Toolstoday.com website, they can be found under the "Boring and Drilling Bits" section.

Reply if you have had any experience with these cutters.
Regards,
Bruce Richards
Logged
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline JMatthew84

  • Posts: 8
Re: Amana Carbite Tipped Bits for Dominos
« Reply #1 on: January 07, 2022, 04:51 PM »
I have the 5mm and its worked well so far, dominos fit nice and tight. Longevity has yet to be determined, but for the price, these are worth giving a try. CMT also makes carbide tipped cutters. Both can be found on amazon as well.
Logged
Pages: [1]   Go Up
« previous next »