Author Topic: Shaper or not ?  (Read 2561 times)

0 Members and 1 Guest are viewing this topic.

Offline colinw

  • Posts: 111
  • Bourbonnais IL 60914
Shaper or not ?
« on: February 12, 2008, 08:30 PM »
My table mounted router finally bit the dust today it has had a long hard life and paid for itself 100 times over, the home made cabinet it sits in has seen better days too and needs to be replaced also. I used it mainly for lots pattern cutting, raised panel doors and rounding over a lot of edges. I have never owned or used a shaper but i am considering a grizzly 1035 or 1026 to replace it (and the $500 or $900 price is pretty attractive since a good quality router table and router is not much cheaper, and do not have the time to construct a new table).  cutter cost is not an issue . I do own a 1400 for out of table work.   Any advice / opinions on either machines, learning curve or anything else you think i should consider.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Scott W.

  • Posts: 333
Re: Shaper or not ?
« Reply #1 on: February 12, 2008, 09:05 PM »
......   Any advice / opinions on either machines, learning curve or anything else you think i should consider.

I have the 3hp Grizz 1026, mine is around 7-8 years old now so I don't know if it's the same machine. It has served me well and I have run thousands of feet of stock through it.

I have a 1hp stock feeder on it.  The fences are a pain to adjust, the arbors not convenient to change but if your turning large cutters or have a lot of the same profile to run there is simply no comparing a shaper to a router table.

That said, I also have a router table with an Incra Ls fence system that is my "go to" machine for small projects. With the ease of set up and accuracy of the LS I can have the boards run in less time it takes to set up & adjust the shaper.

You can see pic's of both here

FYI, if you have never run a shaper, they can be a little "scary" swinging a large cutter  be careful  :)

Scott W.