« previous next »
Pages: [1]   Go Down

Author Topic: Revo clamps  (Read 3073 times)

0 Members and 1 Guest are viewing this topic.

Offline Dovetail65

  • Posts: 4616
    • Rose Farm Floor Medallions and Inlays
Revo clamps
« on: March 09, 2009, 07:18 PM »
And I do want those Revo clamps and your comments Roger just reaffirmed that they will be a nice purchase for the shop. Thanks for posting your comments on them.

I will post my experience with them in a few weeks.
Logged
The one who says it can't be done should avoid interrupting the person doing it.
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Sparky977

  • Posts: 82
    • Mirus Custom Cabinetry
RE: Revo clamps
« Reply #1 on: March 09, 2009, 08:38 PM »
Ok, everything else in this thread aside, that is a freaking impressive sight Roger!
Any chance of a video of that thing running?
Logged
TS 55, RO 125, CT 22 w/ Boomarm, Domino, OF 1400, RS2E, C12, MFT3, 4 guide rails (1080, 1400, 1900, and 2700), Sortainer, Router bit Systainer, Sandpaper Systainer, Domino Systainer

Offline Dave Ronyak

  • Posts: 2234
  • Flyin' from NE Ohio
Re: Revo clamps
« Reply #2 on: March 16, 2009, 11:39 PM »
Hmm, that profile is just about what I need to replicate some mahogany molding in my house!  What a monstrous bit (in a monstrous router)!  The price you paid for the custom bit appears in line with a quote I received from Whiteside; they wanted ~$250 for a much smaller bit with a simple curved profile similar to a "table edge" bit.


Dave R.
Logged
Friends, family and Festools make for a good retirement.  PCs...I'm not so sure.

Offline rnt80

  • Posts: 953
    • Agape Wood Design
Re: Revo clamps
« Reply #3 on: March 17, 2009, 09:14 AM »
Where's the rest of this thread?
Logged
Russell Tribby
Gilbert AZ
www.agapewooddesign.com

Offline Roger Savatteri

  • Posts: 507
    • www.savatteridesigns.com
Re: Revo clamps
« Reply #4 on: March 17, 2009, 10:04 AM »
« Last Edit: March 17, 2009, 10:05 AM by Roger Savatteri »
Logged
Los Angeles, California
Pages: [1]   Go Up
« previous next »