Author Topic: Needed a third hand  (Read 2650 times)

0 Members and 1 Guest are viewing this topic.

Offline JCLP

  • Posts: 900
Needed a third hand
« on: May 21, 2017, 02:21 PM »
Thought I would share another use for woodpecker clamping squares. Used 2 of them to hold something vertical as I glue in dominos.
Cheers,
JC

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline SRSemenza

  • Global Moderator
  • *
  • Posts: 9008
  • Finger Lakes Region, NY State , USA
Re: Needed a third hand
« Reply #1 on: May 21, 2017, 09:12 PM »
Hey, good one!

Seth

Offline ben_r_

  • Posts: 1232
Re: Needed a third hand
« Reply #2 on: May 23, 2017, 04:35 PM »
Yep, thatll work.
If at first you don't succeed, redefine success!

Offline Svar

  • Posts: 1908
Re: Needed a third hand
« Reply #3 on: May 23, 2017, 05:17 PM »
I avoid putting any undue stress on my marking, measuring, or reference tools.

Offline JCLP

  • Posts: 900
Re: Needed a third hand
« Reply #4 on: May 23, 2017, 05:30 PM »
I avoid putting any undue stress on my marking, measuring, or reference tools.
These are clamping squares and are extremely tough. Been ding this for years and of the eight I have all of them are still 100% square.
Cheers,
JC

Offline Svar

  • Posts: 1908
Re: Needed a third hand
« Reply #5 on: May 23, 2017, 05:49 PM »
I avoid putting any undue stress on my marking, measuring, or reference tools.
These are clamping squares and are extremely tough. Been ding this for years and of the eight I have all of them are still 100% square.
Cheers,
JC
I see, my bad. I thought they were measuring squares.

Offline rst

  • Posts: 2277
Re: Needed a third hand
« Reply #6 on: May 23, 2017, 05:52 PM »
I buy 3" x 3"- 1/4" aluminum from 8020 and use my MFT tables to hold parts vertical for processing.

Offline suds

  • Posts: 392
Re: Needed a third hand
« Reply #7 on: May 30, 2017, 06:09 PM »
This has been really convenient for mine.
MFT's, Kapex, TS 55, Vac, 150 Rotrex, 300 Trion, Domino