Author Topic: Milwaukee M12 Fuel right angle die grinder  (Read 386 times)

0 Members and 1 Guest are viewing this topic.

Offline rvieceli

  • Posts: 1158
Milwaukee M12 Fuel right angle die grinder
« on: November 03, 2019, 12:33 PM »
I was going to write up a short review of this new right angle die grinder from Milwaukee but after using it yesterday and today to de-burr and clean up some mild steel, I’m just going to say that if you work with metal in any of your process just buy one.

It’s generally available from most Milwaukee dealers online. right @Shane Holland

It has four speeds from 10,000 to 24500 rpms. Has a 1/4 inch chuck and takes all the M12 batteries although a higher capacity one is better like 4.0 or 6.0

Paired with 2 inch rolocs it is a joy to use. Light, one handed operation and good control over working with a bigger angle grinder.

Quiet compared to a regular grinder and doesn’t have that annoying dentist drill whine like most air powered die grinders.


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline RKA

  • Posts: 1916
Re: Milwaukee M12 Fuel right angle die grinder
« Reply #1 on: November 03, 2019, 02:03 PM »
Thanks for that!  I was debating that or the extended ratchet during the last promo toolnut had.  Ended up with the ratchet, but I’ve convinced myself I’ll have the die grinder when the next promo rolls around.

Offline deepcreek

  • Posts: 906
    • TimberFire Studio
Re: Milwaukee M12 Fuel right angle die grinder
« Reply #2 on: November 03, 2019, 06:27 PM »
Okay, I'm sold.

Thanks for spending my money!   [wink]
Joe Adams
TimberFire Studio
Houston, Texas