Author Topic: MFT/3 Fence and Square ... TSO GRS-16 PE?  (Read 7129 times)

0 Members and 1 Guest are viewing this topic.

Offline Bugsysiegals

  • Posts: 808
Re: MFT/3 Fence and Square ... TSO GRS-16 PE?
« Reply #90 on: January 26, 2021, 03:01 PM »
BTW, how did you end up cutting the Incra fence and getting a decent finish?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Online 08G8V8

  • Posts: 128
Re: MFT/3 Fence and Square ... TSO GRS-16 PE?
« Reply #91 on: January 26, 2021, 03:23 PM »
I used a hack saw and a grinder with a cutoff wheel to get it close, then just used a grinding disc to get the vertical webbing close to flush, and then used a file to get it flush or very close to flush.

A band saw would make much quicker work if it, but don’t have one.


Sent from my iPhone using Tapatalk

Offline Bugsysiegals

  • Posts: 808
Re: MFT/3 Fence and Square ... TSO GRS-16 PE?
« Reply #92 on: January 26, 2021, 03:49 PM »
I used a hack saw and a grinder with a cutoff wheel to get it close, then just used a grinding disc to get the vertical webbing close to flush, and then used a file to get it flush or very close to flush.

A band saw would make much quicker work if it, but don’t have one.


Sent from my iPhone using Tapatalk

Thanks ... same here ... no band saw as I always find some other tools I think I will use more often.