Author Topic: Marita LS1040  (Read 1282 times)

0 Members and 1 Guest are viewing this topic.

Offline Gil B

  • Posts: 1
Marita LS1040
« on: April 11, 2016, 10:57 PM »
I just got a Makita LS1040 and i would like to hook it up to my CT26. the CT26 hose and the saw both have the same outside diameter. Does anyone know of an adapter to hook them up?
I'm also looking at the Mirka Deros, and wanted to know if i would need an adapter for that as well.
Thanks for the help.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Peter_C

  • Posts: 779
Re: Marita LS1040
« Reply #1 on: April 12, 2016, 02:18 AM »
Welcome to FOG :)

Probably best to run a bigger hose up to 2.5" with one of these adapters. I have a Bosch miter saw which works with one of the adapters in the first link, then I run a 1.75" or 2.5" hose to it, depending on the situation.
http://www.homedepot.com/p/RIDGID-3-Piece-Adapter-Kit-VT1755/202077239
http://www.homedepot.com/p/RIDGID-Universal-Power-Tool-Adaptor-VT1407/100206293

Offline Holmz

  • Posts: 4010
Re: Marita LS1040
« Reply #2 on: April 12, 2016, 03:55 AM »
I just got a Makita LS1040 and i would like to hook it up to my CT26. the CT26 hose and the saw both have the same outside diameter. Does anyone know of an adapter to hook them up?
I'm also looking at the Mirka Deros, and wanted to know if i would need an adapter for that as well.
Thanks for the help.

On my DEROS I just slide the CT26 over and it worked.
(If it is 230v then the DEROS 5250 has the 5" and 6" pads.)