Author Topic: Kreg’s new table  (Read 1305 times)

0 Members and 1 Guest are viewing this topic.

Offline bury

  • Posts: 1
Kreg’s new table
« on: March 03, 2019, 02:11 PM »
Can  the Festool rail  replace Kreg’s rail on the table
If not
Can the Festool saw 55 replace Kreg’s saw
« Last Edit: March 04, 2019, 09:08 PM by bury »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline tomp

  • Posts: 110
Re: Kreg’s new table
« Reply #1 on: March 03, 2019, 02:41 PM »
Looking at the manual

https://www.kregtool.com/webres/Files/ACS/Manual/Kreg-ACS-Project-Table-Manual%20(NK9318).pdf

it appears that the track is attached to the hinge at each end using a bolt and t-slot nut, slightly different than the MFT, but this is probably because it's attached at both ends. To use the Festool track, the t-slot nut would have to be a snug fit in the track so there is no side-to-side play, this to keep the track square to the hinges and so to the table. IMO I think that the movable guide stops may be a better way to set the cut size than an arm that attaches to the outer groove of the track.

Offline Michael Kellough

  • Posts: 4823
Re: Kreg’s new table
« Reply #2 on: March 03, 2019, 03:12 PM »
In another thread about the Kreg table, Shane said the ToolNut guys thought the Festool rail could be installed on the Kreg table without too much trouble. The saws though are not interchangeable in any sense.

Offline JD2720

  • Posts: 1132
Re: Kreg’s new table
« Reply #3 on: March 03, 2019, 05:50 PM »
From the manual, it looks like a Festool rail could be mounted on the table.