Author Topic: Tablesaw Fundamentals with Marc Adams  (Read 490 times)

0 Members and 1 Guest are viewing this topic.

Offline GoingMyWay

  • Posts: 1081
Tablesaw Fundamentals with Marc Adams
« on: May 12, 2020, 02:48 PM »
I just watched Tablesaw Fundamentals with Marc Adams.  I don't even own a tablesaw, but I found it contained lots of good information:
Inquiring Minds Want to Know

TS55, CT26, RO150, CXS, ETS 150/3, ETS EC 150/5, MFT/3, TS75, DF500, DTS400, OF1400, CT SYS

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Mario Turcot

  • Posts: 1230
Re: Tablesaw Fundamentals with Marc Adams
« Reply #1 on: May 15, 2020, 12:46 AM »
Yes a lot of tips and tricks and jigs and even more double side tape  [wink]

Thanks for sharing  [thumbs up]
Mario