« previous next »
Pages: [1]   Go Down

Author Topic: Izzy Swan Sawstop infeed table  (Read 393 times)

0 Members and 1 Guest are viewing this topic.

Offline zachjowi

  • Posts: 95
Izzy Swan Sawstop infeed table
« on: June 18, 2022, 09:09 PM »
I purchased an Izzy Swan infeed table from a thrift store but it looks like it is missing the front angle part.  Does anyone know what the dimensions are for that piece?

Thanks

https://www.izzyswan.com/Store/In-Feed-Table-for-Standard-Table-Saws-p237211510
Logged
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Bob D.

  • Retailer
  • *
  • Posts: 2799
    • My Cordless Workshop
Re: Izzy Swan Sawstop infeed table
« Reply #1 on: June 18, 2022, 10:02 PM »
I don't know the dimensions, but it should be the width of the top piece that you have. The depth should be slightly less than the depth of the gap between your rail and the front edge of the tablesaw top.

But actually I think you have the version that was made for the DeWalt jobsite saw. Watch this video where Izzy shows setting it up. It looks a lot like what you have.

« Last Edit: June 18, 2022, 10:04 PM by Bob D. »
Logged
-----
It's a table saw, do you know where your fingers are?

Online DynaGlide

  • Posts: 1431
Re: Izzy Swan Sawstop infeed table
« Reply #2 on: June 19, 2022, 05:06 AM »
@zachjowi if Bob is right and yours won't work let me know as I have a DeWalt job site saw. I haven't watched the video yet
Logged
Instagram @matts.garage
Pages: [1]   Go Up
« previous next »