Author Topic: T-tracks with joiners?  (Read 1316 times)

0 Members and 1 Guest are viewing this topic.

Offline fritter63

  • Retailer
  • *
  • Posts: 1447
T-tracks with joiners?
« on: December 27, 2021, 06:03 PM »
Does anyone know of a source for T-tracks that can use joiner bars? Similar to how Festool tracks can be joined together (or the 8020 extrusions as well).

Or are there any t-tracks that would be compatible with the Festool joiners?

Thanks.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline JD2720

  • Posts: 1255
Re: T-tracks with joiners?
« Reply #1 on: December 27, 2021, 06:51 PM »
Check the wood pecker web site.

Offline fritter63

  • Retailer
  • *
  • Posts: 1447
Re: T-tracks with joiners?
« Reply #2 on: December 28, 2021, 11:20 AM »
Check the wood pecker web site.

First place I looked. Was surprised. :)

Offline fritter63

  • Retailer
  • *
  • Posts: 1447
Re: T-tracks with joiners?
« Reply #3 on: December 28, 2021, 09:03 PM »
So, baring another discovery, I think the trick will be woodpeckers T-track. They have several sizes of joiners that are sold with their parallel guide system, maybe I can get them to sell me a couple of those. Assuming that t-track is the same as the extrusions they used for the guides.