Author Topic: Incra LS positioner mounting.  (Read 1305 times)

0 Members and 1 Guest are viewing this topic.

Offline Sparky

  • Posts: 158
Incra LS positioner mounting.
« on: July 24, 2015, 02:26 PM »
Ok so I have decided it time for a router table. I can either build a bigger extension wing in my sawstop pcs with 36" fence or I can build a separate table. Because of the clearances needed for the incra ls positioner I am not sure if it makes sense to put in wing. If I build a table was thinking about also being able to use as a outfeed table also but wondering in anyone has came up with a quick way to pull off the positioner fence like maybe using bench dog hole??? Any ideas would be great as I am just starting to plan this out as I am confined to the house and not very mobile yet from surgery.
Ct 36, Ets 150/3, OF1400, Lr32 Set, domino 700 set, hl850, ts 75,Dts 400, kapex

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline irishman

  • Posts: 35
Re: Incra LS positioner mounting.
« Reply #1 on: July 24, 2015, 03:03 PM »
I have but a custom extension for mine on the side of my tablesaw.  I mounted my LS positioner to a 3/4" plate and that plate mounts to the router table with T-tracks.  Keeps it easily removeable and out of the way.  most times for what I need I just use the tablesaw fence, but for repeatable precision, I breakout this setup.

Offline Sparky

  • Posts: 158
Re: Incra LS positioner mounting.
« Reply #2 on: July 24, 2015, 03:16 PM »
Any chance you could post some pictures when you get the chance? Would love to see pictures from several people :-)
Ct 36, Ets 150/3, OF1400, Lr32 Set, domino 700 set, hl850, ts 75,Dts 400, kapex

Offline SRSemenza

  • Global Moderator
  • *
  • Posts: 9008
  • Finger Lakes Region, NY State , USA
Re: Incra LS positioner mounting.
« Reply #3 on: July 24, 2015, 05:57 PM »
   If you've got room for the separate table, then go that way. Keeps everything in full ready mode all the time and no fiddling if you want both set up at the same time.

Seth