Author Topic: Fury bristle to help with dust collection/extraction  (Read 1049 times)

0 Members and 1 Guest are viewing this topic.

Offline doctr-dan

  • Posts: 18
Fury bristle to help with dust collection/extraction
« on: September 06, 2015, 07:54 AM »
Hi all,
A little while back someone posted about using bristles on some bendy sticky backing around the rear of the dropsaw and the sides of a table saw to assist with stopping dust flying everywhere and giving the dust extraction unit more of a chance to collect it.
I have old makita ls1212 dropsaw which funnily enough my local festool dealer says there s only 2 good dropsaws around, the kapex and the ls1212.
Anyway I was thinking of attaching some of these bristles behind the blade to stop the dust flying everywhere.
I have no idea where to find some so any help would be appreciated

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Wuffles

  • Posts: 1313
Re: Fury bristle to help with dust collection/extraction
« Reply #1 on: September 06, 2015, 08:08 AM »
Sounds like an old fashioned draught excluder that would be sold on a strip of bendable metal you would screw to a door. Perhaps the bristles wouldn't be long enough though.
Tool list updated to reflect knowledge :: hammer, screwdriver, one pozi bit, and another bigger hammer.

Offline Frank-Jan

  • Posts: 1043
  • Dutch Canadian living in Belgium
Re: Fury bristle to help with dust collection/extraction
« Reply #2 on: September 06, 2015, 08:32 AM »
I couldn't find the thread about the dustshroud modification for the kapex, (there were a few links in it that mentioned where you could buy the bristles), but I did remember that fastcap offered it too: link to sawstache