Author Topic: Enablers  (Read 597 times)

0 Members and 1 Guest are viewing this topic.

Offline WarnerConstCo.

  • Posts: 4162
    • Warner Mill Works
Enablers
« on: October 18, 2020, 02:14 PM »
Thanks to a really good enabler, i managed to buy this from 3 hours away while I was picking up other equipment.
16" Wadkin jointer

Sent from my SM-N960U using Tapatalk


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline rvieceli

  • Posts: 1409
Re: Enablers
« Reply #1 on: October 18, 2020, 02:38 PM »
Nice

Offline WarnerConstCo.

  • Posts: 4162
    • Warner Mill Works
Re: Enablers
« Reply #2 on: October 18, 2020, 02:39 PM »
Nice
So is that oliver you picked up, I didn't have to drive that far though.

Sent from my SM-N960U using Tapatalk


Offline rvieceli

  • Posts: 1409
Re: Enablers
« Reply #3 on: October 18, 2020, 03:58 PM »
@WarnerConstCo.

Thanks Darcy. Hey while I've got you here. What's the maintenance of the Allis direct drive motor on it?

I also can't seem to find a decent manual on adjustments anywhere, got any resources?

Thanks

Ron

Offline WarnerConstCo.

  • Posts: 4162
    • Warner Mill Works
Re: Enablers
« Reply #4 on: October 18, 2020, 05:59 PM »


@WarnerConstCo.

Thanks Darcy. Hey while I've got you here. What's the maintenance of the Allis direct drive motor on it?

I also can't seem to find a decent manual on adjustments anywhere, got any resources?

Thanks

Ron


Not much really for the motor.
Is it still set up for oiled bearings? 

You can order a manual and copy of the original sales invoice from Rich at Eagle Machinery. Cost about 80 bucks for both.



Sent from my SM-N960U using Tapatalk


Offline rvieceli

  • Posts: 1409
Re: Enablers
« Reply #5 on: October 18, 2020, 06:26 PM »
Still has oiled bearings and has oil in the cups.  [smile]

Thanks

Ron