Author Topic: Drilling Iroko for Hole Plug  (Read 1071 times)

0 Members and 1 Guest are viewing this topic.

Offline The Pipdoc

  • Posts: 7
Drilling Iroko for Hole Plug
« on: October 12, 2014, 03:21 PM »
I have ordered a bag of 12mm tapered Iroko plugs for a job I'm about to start tomorrow ( for myself I should add).
My question is  -  will I be able to use a 12mm router to cut the hole?
Will a router but cut cleanly?
This might sound like a daft question but I've never worked on anything other than softwood in the past.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.