Author Topic: Sharpening Multimaster Blades  (Read 1524 times)

0 Members and 1 Guest are viewing this topic.

Offline T. Ernsberger

  • Posts: 895
Sharpening Multimaster Blades
« on: September 22, 2015, 08:05 PM »
I have a hand full of Mulimaster Blades that are dull.  Do sharpening shops resharpen these kind of blades?  Are they worth sharpening when they cost $12?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline RJNeal

  • Posts: 606
Re: Sharpening Multimaster Blades
« Reply #1 on: September 22, 2015, 09:14 PM »
I have been known to touch up worn out blades with a zip blade to make a coarse cutting blade. I just did this yesterday to be able to cut some trex decking.
I also glue sand paper to worn out blades so you can sand bottoms of doors and things.
Have you walked your saw today?