Author Topic: Bosch T4b Gravity rise vs. Best fence pro  (Read 2049 times)

0 Members and 1 Guest are viewing this topic.

Offline PattyO

  • Posts: 8
Bosch T4b Gravity rise vs. Best fence pro
« on: October 21, 2015, 09:59 PM »
Hi Guys,

 Its time to get a new Miter saw and stand, and I have narrowed the stand down to two…... I figure I will be getting the best fence (fence) no matter what, but can't seem to settle on a stand. Both the Bosch and Best Fence pro seem to have redeeming qualities. I am hoping to get some opinions that might help me make this decision. Thanks in advance.

Relavent info...I am a deck and fence builder/remodeler. I have a long wheel base Sprinter, so space in the vehicle is not an issue. The saw will live in my van. I plan to get the 1016 makita 10in saw(can't justify Kapex for my kind of work).  I have been working with a 12 dewalt, and a very heavy cheap stand….can not wait to upgrade.

Thanks,

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline JD2720

  • Posts: 1106
Re: Bosch T4b Gravity rise vs. Best fence pro
« Reply #1 on: October 21, 2015, 11:07 PM »
I have a Bosch gravity table saw stand, it works similar the miter saw stand. I also have a Dewalt  DWX726 miter saw stand. Both stands work fine after they are setup, but I much prefer the Dewalt stand when it comes to setup & taking down. The Bosh stand has to be stood up on end before setting up & has to be tilted back up on end to fold up. When taking the Bosch down, it wants to drop, so I have to be sure to hold on tight to it. The Dewalt stand is laid flat on the floor. To raise it, pull a lever & lift up. To take down, lift slightly, pull the lever & lower it down. Then lift one end to move it. It can be stored on end. There are some  good videos on You Tube showing how both stands work.  I did add a piece of plywood to the top of  the Dewalt stand. I have a Kapex & and 2 Dewalt miter saws. I can quickly mount & unmount any of the saws.