« previous next »
Pages: [1]   Go Down

Author Topic: Sawstop Jobsite Pro Enhancements!  (Read 1077 times)

0 Members and 1 Guest are viewing this topic.

Offline Goldserve

  • Posts: 44
Sawstop Jobsite Pro Enhancements!
« on: July 24, 2021, 04:29 PM »
For a small garage, i'm loving the improved dust collection of the SawStop job site pro. The upgrade router table insert from my previous Kreg is nice. The Jessem stock guides that can be used for both the router fence and saw is really nice! Finally, the clamp on outfield extension is perfect for narrow stock that I usually work with. Hope it inspires some of you!

Imgur
Logged
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline 08G8V8

  • Posts: 148
Re: Sawstop Jobsite Pro Enhancements!
« Reply #1 on: July 24, 2021, 05:39 PM »
Very nice setup! 

I recently added an insert panel to mine to fill in that open area where you installed your router so I can just keep it in the extended mode. I have a dedicated router table.



I also added the Wixey WR700 digital fence.  Not my idea, but saw another guy on Facebook Sawstop page did it, and thought it was an excellent idea. Gives the ability to work in metric and imperial. Had to drill and tap (1) additional hole in the stock fence.

Determining bracket requirements:



Final install:



I’ve got the JessEm Clear Cut Guides and I’m going to make an attachment similar to this setup, from the same guy who did the Wixey WR700.  The digital readout also will allow recalibration when the JessEm Guide jig is attached to account for the added fence thickness.




I’ve had the saw for about 6 months but haven’t built anything with it yet, but cut up material this weekend for some drawers for a drillpress cabinet I’m making.  Very nice, and happy with the Jobsite Pro.


Sent from my iPad using Tapatalk Pro
Logged
Pages: [1]   Go Up
« previous next »