Author Topic: Anybody have an idea what tool is being used  (Read 1711 times)

0 Members and 1 Guest are viewing this topic.

Offline rsausa

  • Posts: 49
Anybody have an idea what tool is being used
« on: March 21, 2016, 02:29 PM »
At approx 2.00 min mark a "file" is used instead of a chisel ....very cool idea... and great way to set up the board as well to get a 90 degree flush joint
Name of tool? can it be purchased ?



Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline crampedshop

  • Posts: 47
Re: Anybody have an idea what tool is being used
« Reply #1 on: March 21, 2016, 03:40 PM »

Offline Holmz

  • Posts: 4010
Re: Anybody have an idea what tool is being used
« Reply #2 on: March 21, 2016, 03:51 PM »
The one 2: Looked like a rasp, which is a sort of file.
Like sanding, it is hard to have a straight "cut" and not roll the edge over.

Offline alexander

  • Posts: 26
Re: Anybody have an idea what tool is being used
« Reply #3 on: March 21, 2016, 04:02 PM »
Looks like some custom joinery float.

Lie Nielsen have some, but not like that.

https://www.lie-nielsen.com/nodes/4089/joinery-floats

Alex

Offline Jak147

  • Posts: 113
Re: Anybody have an idea what tool is being used
« Reply #4 on: March 21, 2016, 04:12 PM »
To my eyes it looks like 4-5 blades clamped together

Offline Matthewajones

  • Posts: 206
Re: Anybody have an idea what tool is being used
« Reply #5 on: March 21, 2016, 09:10 PM »
Looks like some custom joinery float.

Lie Nielsen have some, but not like that.

https://www.lie-nielsen.com/nodes/4089/joinery-floats

Alex

Why did you show me those???.... now I have to buy a set....lol