« previous next »
Pages: [1]   Go Down

Author Topic: True Position Jig  (Read 894 times)

0 Members and 1 Guest are viewing this topic.

Offline Birdhunter

  • Posts: 3946
  • Woodworker, Sportsman, Retired
True Position Jig
« on: June 15, 2022, 05:34 PM »
I’m building my first (and only) dresser. It has 6 drawers each 30” wide and 10” high. The pulls are black steel each 10” long. They contrast nicely against the quarter sawn white oak.

Any misalignment will be very obvious and difficult to remedy.

I ordered a True Position jig. It works! Great product. Expensive, but excellent for an amateur like me. I could probably make a jig, but I would spent too much time for a one-off use.
Logged
Birdhunter
Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Pages: [1]   Go Up
« previous next »