Author Topic: PC4200 with Leigh VRS1200  (Read 1103 times)

0 Members and 1 Guest are viewing this topic.

Offline BarneyD

  • Posts: 82
PC4200 with Leigh VRS1200
« on: May 05, 2019, 04:54 PM »
For the past 10 years I've been cutting HB dovetails with a PC 4200 router jig. It does a good job but it throws chips and dust everywhere. I recently saw that Leigh has come out with an attachment which looked promising. I ordered one from Highland and just got to use it for the first time today. It's a little tedious to initially set up. You have to get it level with the fingers on the PC4200. To do this you have to assemble, measure, disassemble, adjust some little set screws, reassemble, measure again, rinse and repeat until you get it level. But you only have to do this once during initial setup. Thereafter you can grab and go. 



There's a little "sled" under the bar to which you can attached a vac hose. I hooked mine to my CT26 with UDD and this provided excellent results. Below you can see that the sled has little "ears". The collar on your router will push the sled along as you travel along the board. I'd say it sucked up about 99% of the debris. The only time you get a bit of blowby is when you get to the far right side of the tail board. There the sled extends beyond the tail board and so loses a bit of effectiveness.



I'm very happy with it.
Barney

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.