Author Topic: User Upgrade to the Veritas Domino Joinery Table  (Read 515 times)

0 Members and 1 Guest are viewing this topic.

Offline ChuckS

  • Posts: 4012
User Upgrade to the Veritas Domino Joinery Table
« on: August 20, 2022, 06:55 PM »
After making the long drawer for the table saw with the Veritas Domino Joinery Table (https://www.festoolownersgroup.com/member-projects/first-veritas-joinery-table-project-table-saw-front-rail-drawer/msg674155/#msg674155), I took time to build two drawers (out of scrap 6mm ply) to make good use of the space underneath the joinery table. (The previous plastic case for storing the joinery table accessories is shown at the end.)

The offset registration gauge worked perfectly as designed, allowing identical parts to be milled without placement lines marked.














« Last Edit: August 20, 2022, 06:59 PM by ChuckS »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.