Author Topic: Tool Storage 2 (Systainer)  (Read 764 times)

0 Members and 1 Guest are viewing this topic.

Offline Fredbear

  • Posts: 13
Tool Storage 2 (Systainer)
« on: September 19, 2021, 02:53 PM »
I thought I’d share my latest systainer storage solution.
I over ordered some mfc for a project and decided to use it to make better use of the space behind the Kapex.
« Last Edit: September 27, 2021, 05:47 PM by Fredbear »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Mortiser

  • Posts: 104
Re: Tool Storage 2 (Systainer)
« Reply #1 on: September 19, 2021, 02:58 PM »
Very nice @Fredbear . Thanks for sharing, and sending along the photos.
Enjoy your new shop setup.

Offline Crazyraceguy

  • Posts: 831
Re: Tool Storage 2 (Systainer)
« Reply #2 on: September 19, 2021, 05:29 PM »
That's a good looking set-up.
DF500 + assortment set
PS420 + Base kit
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
ETS EC 125
ETS 125 (2)
Shaper Origin/Workstation