Author Topic: First Veritas joinery table project -- Table saw front rail drawer  (Read 491 times)

0 Members and 1 Guest are viewing this topic.

Offline ChuckS

  • Posts: 3981
Based on the idea of a magazine's shop tip, I did a quick long drawer project using the DF500 and the Veritas joinery table. All came out well, including milling all the mortises without having the table clamped to the bench.

In the original tip, 1/4" and 1/2" ply materials were used with glue and nails. I chose 5mm ply because the SawStop front rail opening is only 45mm (H) x 70mm (W). Due to the mounting bolts protruding inside the rail, the drawer could only be made to the size of 35mm x 65mm (x 900mm).

I put all the hex keys, bypass keys, blade adjustment kit, screwdriver,  etc. that came with the SawStop saw as well as a few other things in the drawer. Of course, the plastic rail cap, too.




















« Last Edit: August 08, 2022, 12:30 PM by ChuckS »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.