Author Topic: Back to the miterfold project  (Read 468 times)

0 Members and 1 Guest are viewing this topic.

Offline Crazyraceguy

  • Posts: 1668
Back to the miterfold project
« on: June 19, 2022, 09:54 AM »
I have shown pics of earlier versions of these objects, but always in the finished state. Here are a few of the process in a bit more detail, showing the whole line taped up and the core that it wraps around too. I cut up the laminate pieces Friday on the side table, which shows the cut lines and some of the rough measurements I use to cut the parts. Saturday morning, I did the mitering and glue-ups.
More boxes in this style to come next week.
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1010F
OF1400
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)
TS75
Shaper Origin/Workstation
MFT clamps set

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline rvieceli

  • Posts: 1736
Re: Back to the miterfold project
« Reply #1 on: June 19, 2022, 10:07 AM »
@Crazyraceguy excellent work as always. What is that substrate you are using?

Ron

Offline Crazyraceguy

  • Posts: 1668
Re: Back to the miterfold project
« Reply #2 on: June 19, 2022, 10:13 AM »
It's just ordinary 3/4" particle board. There will be a small plywood toe-kick with adjustable feet, to keep it off of the floor.
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1010F
OF1400
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)
TS75
Shaper Origin/Workstation
MFT clamps set

Offline Crazyraceguy

  • Posts: 1668
Re: Back to the miterfold project
« Reply #3 on: June 20, 2022, 06:07 PM »
More pics from today. I got the two smaller units done and the parts made for the larger ones.
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1010F
OF1400
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)
TS75
Shaper Origin/Workstation
MFT clamps set