Author Topic: Small table  (Read 426 times)

0 Members and 1 Guest are viewing this topic.

Offline Joelm

  • Posts: 118
Small table
« on: April 11, 2021, 02:36 PM »
My wife bought a round couch for our living room and has been complaining she didn't have anywhere to put down her coffee. She didn't like any of the tables she saw online but did like a table top. So she bought it and sent me to the workshop with a job. I bought a 8/4 white oak board from my local supplier and got to work. This was more of an organic process rather than starting with a design first.

I reused a template I made for our coffee table I finished at Christmas.
330257-0

After trying out 4 legs we decided 3 legs would look better. We decided on half lap joints that intersect and overlapped to create a triangle. I tried my and at cutting these with just hand tools. The glue up was a bit tricky but I ended up finding some offcuts that were the correct triangle and I made a jig with a few scraps.
330259-1330261-2

The joints turned out a bit messier than I would have liked but you don't actually see it when the table top is installed. My wife is very happy with how it turned out though, so that's all that matters.
330263-3330265-4


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Peter_C

  • Posts: 1094
Re: Small table
« Reply #1 on: April 11, 2021, 03:04 PM »
What a beautiful plant stand it would make too ;)

Offline Bob D.

  • Posts: 2132
Re: Small table
« Reply #2 on: April 11, 2021, 03:19 PM »
What a beautiful plant stand it would make too ;)

Yes, it would. Hope the wife doesn't see this. :-)
-----
It's a table saw, do you know where your fingers are?