Author Topic: serving tray  (Read 735 times)

0 Members and 1 Guest are viewing this topic.

Offline HowardH

  • Posts: 1338
serving tray
« on: December 27, 2019, 08:11 PM »
I had a bunch of walnut laying around and decided to do something with it.  For the dovetails, I hadn't used my Leigh Super Jig in a long time so it was like using it for the first time all over again.  A few trial runs with pine and it was ready to go.  I did find cutting the through dovetails was going to be easier with the OF1400 rather than the OF2200.  I connected the mullions with a half lap which also required a test run.  I'll give to my son for his dorm room to help dress it up a bit. 


Howard H
The Dallas Texas Festool Fanatic!

Mark Twain:  "I didn't attend the funeral, but I sent a letter approving of it." "If you tell the truth you don't have to remember anything."

mft1080, P1cc, MFT/3, T15, TID-18, RO150FEQ, MT55cc, RTS400, CT22, CT36E, 800, 1080, 1400, 1900 rails, OF 2200, OF1400, CSX, C18, VacSys, Vecturo, Qwas dogs, Parf Dogs, Zobo's, Syslite Uni, CMS GE. Mafell DDF40, Sawstop contractor, PM 1500, Shaper Origin. Felder AF-14

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline SoonerFan

  • Posts: 493
Re: serving tray
« Reply #1 on: December 27, 2019, 08:40 PM »
@HowardH nice work.  I for sure never had anything that nice in my dorm room.