Author Topic: Second barn wood project  (Read 416 times)

0 Members and 1 Guest are viewing this topic.

Offline Crazyraceguy

  • Posts: 587
Second barn wood project
« on: March 19, 2021, 11:01 AM »
It's strange for this to come up so soon. I just finished that last desk a few weeks ago and here is another project with even more?
This one is much more involved. It is a basement bar with base cabinets (not pictured here) that have very dark stained maple flat panel doors and an end panel of the weathered wood. This upper shroud goes on a stone countertop that someone else is fabricating. This all goes against a wall/corner.
Then a peninsula goes in front of it, with the same style doors and more of the weathered barn wood covering it. The end cabinets will get doors with a wire mesh, but they were still in the finish department when I took these pics. It will also get a top cap that bridges across the cabinets and will have some more lights too.
The TS55 made this a far easier project than the time I worked with this stiff years ago. Unlike the desk I did a few weeks ago, this one has pieces with worn/weathered edges too. Sounds simple, except that none of the boards available were the correct width. The track makes it easy to cut a straight edge on a crooked board. I did it with a sled last time and it works ok for square edges, but beveling those edges at 45 degrees to miter-fold was not as easy.
Most of the overlay pieces on this were either mitered around a corner or to return the edges of boards that were too wide. I have no idea what the tops will look like, but will post update pics when it gets installed.
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1400
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)
TS75

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline jobsworth

  • Posts: 6724
  • Festool Baby.....
Re: Second barn wood project
« Reply #1 on: March 20, 2021, 12:15 PM »
Looks great. I have to make couple of them and have need to make them for a while. One of these days I get around to it guess.