Festool Owners Group

GENERAL DISCUSSIONS => Member Projects => Topic started by: Birdhunter on December 13, 2019, 02:51 AM

Title: Router Table Laser
Post by: Birdhunter on December 13, 2019, 02:51 AM
In cutting stopped dados and other cuts on my router table, I often wish I had a sharply focused laser lines that crisply delineated where the front and back of the bit were. I have that feature on my Kapex. I could see the two lasers on goosenecks attached to my router fence providing the lines.

Does anyone make such a tool?
Title: Re: Router Table Laser
Post by: Bob D. on December 13, 2019, 05:33 AM
In place of mounting on gooseneck arms what about embedded in the table top.

Title: Re: Router Table Laser
Post by: DynaGlide on December 13, 2019, 09:03 AM
In cutting stopped dados and other cuts on my router table, I often wish I had a sharply focused laser lines that crisply delineated where the front and back of the bit were. I have that feature on my Kapex. I could see the two lasers on goosenecks attached to my router fence providing the lines.

Does anyone make such a tool?

@Birdhunter Perhaps a different angle to attack this problem: http://www.youtube.com/watch?v=dLJXcB18a8o (http://www.youtube.com/watch?v=dLJXcB18a8o)

Skip to the 5:44 mark.