Author Topic: Rift-sawn white oak countertop: Scribe to wall or backsplash moulding??  (Read 487 times)

0 Members and 1 Guest are viewing this topic.

Offline Jasmin

  • Posts: 6
Hi,

I just finished a rift-sawn white oak countertop but I am unsure about the transition to the wall. Scribed would look better but I am worried about wood movement. Do I need a small "backsplash" moulding for the transition to the wall?

Picture below.

Thanks!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline jeffinsgf

  • Retailer
  • *
  • Posts: 490
  • Woodpeckers Marketing Department
Looks like a job for a thin bead of clear silicone.

Offline denovo

  • Posts: 87
It looks great!  I'd scribe to the wall and if you do have movement causing a gap then add the backsplash moulding

Offline Crazyraceguy

  • Posts: 1578
Looks like a job for a thin bead of clear silicone.

Agreed, with one slight change. I would use clear Latex caulking. It will seal the space just the same, but it is far easier to apply/clean-up and it is not shiny, thus not attracting the eye to the fact that is even there.
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1010F
OF1400
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)
TS75
Shaper Origin/Workstation
MFT clamps set