Author Topic: pass-thru aquarium stand  (Read 411 times)

0 Members and 1 Guest are viewing this topic.

Offline Crazyraceguy

  • Posts: 831
pass-thru aquarium stand
« on: November 07, 2021, 03:34 PM »
Last weeks project of a surround for a large aquarium that is totally non-supporting of the tank itself.
Apparently this goes between 2 rooms to be viewed from both sides. The Corian top will be notched around the wall when being installed and each half gets attached to the wall itself. There are connecting panels (not shown) that connect and fill-in the space where the inside of the upper sections do not meet  and the wall would be exposed.
It also shows the aluminum U channel in the space between panels, as mentioned in my last project post.
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1400
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)
TS75
Shaper Origin/Workstation

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline tsmi243

  • Posts: 144
Re: pass-thru aquarium stand
« Reply #1 on: November 07, 2021, 05:18 PM »
Please tell me you can snag some pics of the install


Offline Crazyraceguy

  • Posts: 831
Re: pass-thru aquarium stand
« Reply #2 on: November 08, 2021, 10:21 AM »
Please tell me you can snag some pics of the install

I hope so. I did have the upper sections on top of the whole unit once at the end of the day Thursday, but didn't take a pic at that point, thinking that it would be back up there again before it shipped out on Monday. I never did though and it is supposed to go today. I'm not going to be there all this week, so it should be long done before I get back. I won't be there to ask, but I hope someone thinks to take a pic. I have no idea if this tank is already in-place and filled/functioning. I don't think it is, but this just wraps around, so it wouldn't really matter.
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1400
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)
TS75
Shaper Origin/Workstation