Author Topic: My MFT Table  (Read 3673 times)

0 Members and 1 Guest are viewing this topic.

Offline Wayne CW

  • Posts: 39
  • Wayne
My MFT Table
« on: May 05, 2021, 03:24 PM »
I have been designing and putting together a work station to utilize my track saw in my shop. Not as fancy as some i've seen buy i've just tried to keep things as simple yet as functional as i can make it. Probably a bit higher then most but i wanted something i didn't need to bend over. I am looking at a nice fence at Axminster Tools the has a flip stop for repetitive cuts and it uses the dog holes which would work nicely for me. Its a work in progress but coming along nicely.

I used the Parf Guide to layout the holes. I know the guide is a little pricey but i liked the ability to layout my own top and i think its uses are endless as with the fence i made using it. I can also make a smaller top and a couple of horses for off site.
"There is always something new to learn and old age isn't an excuse to quit."

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline nicholam77

  • Posts: 110
Re: My MFT Table
« Reply #1 on: May 10, 2021, 10:47 AM »
Looks good to me! I like the angle fence.
CT15 | ETS 125 REQ

Offline Don T

  • Posts: 2074
  • Phoenix, Az
Re: My MFT Table
« Reply #2 on: May 10, 2021, 01:23 PM »
Looks great!  Solid design.
RO150, C12, DF 500 Q, CT33, TS75, MFT3, Kapex 120, MFT3/Kapex, MFK 700, RO 90, ETS150/3, CT22, Centrotec Installers Kit, Parallel Guides & Ext, Carvex, OF1400, LR32 Set, MFS400 w/700 rails, KA UG Set, First Aid Kit, RTS 400 EQ, Vecturo OS400 Set, CT Wings, CT Drill Guide, Pro 5, CXS, C18, HL850, Vac Sys set