Author Topic: Low Profile Dust Collector for my CT Mini  (Read 725 times)

0 Members and 1 Guest are viewing this topic.

Offline siganberg

  • Posts: 1
Low Profile Dust Collector for my CT Mini
« on: November 26, 2020, 10:27 PM »
Been using Dust Deputy for a while now but kinda don't like the form factor, too tall. Then I saw the CT Cyclone but according to my research, is not compatible with my old CT Mini. Saw a few custom project, some of them are using Dustopper but that one is also wide.

Since I have a 3D printer, I did try to design my own including the low-profile cyclone that almost the same as the CT Cyclone. I've finished the design and will try to build this later. I Will be also using a 3D printed latch to lock the lower and upper part together and 3D printed feet to attach it to my CT mini.








Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Jack01

  • Posts: 35
Re: Low Profile Dust Collector for my CT Mini
« Reply #1 on: March 26, 2021, 12:18 AM »
This is old post, just curious have you built this?