Author Topic: Long distance project  (Read 320 times)

0 Members and 1 Guest are viewing this topic.

Offline Crazyraceguy

  • Posts: 505
Long distance project
« on: May 01, 2021, 05:39 PM »
This is very different from the usual project in that it was designed from the beginning to be stained/finished and assembled by homeowners with no woodworking skills and packed to ship.
The base is a piece that they already had. The upper shroud was constructed with maple ply using a combination of 6mm Dominos and Lamello Zeta P2 hardware. The back is probably the most complex part because of the necessity of break-down for shipping.
The vertical partitions and sides are intended to be permanent, so they are assembled with glued Dominos and Tenso fasteners. This eliminated the need for clamps that the average person wouldn't have.
The upper part of the back, above the shelf, is in two pieces. This is because of grain direction/width.
They are just overlapping rabbets and screws. The lower back is three pieces, joined with Dominos and Clamex connectors. The hex key holes face toward the back, making it easier to assemble, again without clamps. This was also because of shipping size parts.
This whole thing was then packed into two separate boxes and shipped over 1500 miles via Fedex.
They obviously got it finished and assembled just fine.
Not the greatest picture because it is dead-on from the front, you can't see the sides.
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1400
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)
TS75

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.