Author Topic: latest CB creation  (Read 389 times)

0 Members and 1 Guest are viewing this topic.

Offline HowardH

  • Posts: 1186
latest CB creation
« on: November 18, 2019, 12:03 PM »
I recently purchased a set of edge banding router bits and tried them out to create a board with chevrons.  I think it came out pretty well for a first attempt.  It's pretty time consuming with the CMS-GE router set up so the next time I decide to make some for sale, I'm going to cut a bunch of strips so I can make several at at a time. 

Howard H
The Dallas Texas Festool Fanatic!

Mark Twain:  "I didn't attend the funeral, but I sent a letter approving of it." "If you tell the truth you don't have to remember anything."

mft1080, Trion, MFT/3, T15, OF 1400, RO150FEQ, TS55, RTS400, CT22, CT36E, 800, 1080, 1400, 1900 rails, CSX, C18, Vecturo, Qwas dogs, Parf Dogs, Zobo's, Syslite Uni, CMS GE with router and jig saw plates.  Sawstop contractor.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline mike_aa

  • Posts: 1097
Re: latest CB creation
« Reply #1 on: November 18, 2019, 01:00 PM »
Nice!  Thanks for sharing.

Mike A.

Offline HowardH

  • Posts: 1186
Re: latest CB creation
« Reply #2 on: November 18, 2019, 02:58 PM »
Thanks. People will be scratching their heads trying to figure out how it was made.  Like the old commercial, It's an ancient chinese secret! 
Howard H
The Dallas Texas Festool Fanatic!

Mark Twain:  "I didn't attend the funeral, but I sent a letter approving of it." "If you tell the truth you don't have to remember anything."

mft1080, Trion, MFT/3, T15, OF 1400, RO150FEQ, TS55, RTS400, CT22, CT36E, 800, 1080, 1400, 1900 rails, CSX, C18, Vecturo, Qwas dogs, Parf Dogs, Zobo's, Syslite Uni, CMS GE with router and jig saw plates.  Sawstop contractor.