Author Topic: Huge cornice  (Read 641 times)

0 Members and 1 Guest are viewing this topic.

Offline Crazyraceguy

  • Posts: 831
Huge cornice
« on: November 17, 2021, 07:18 PM »
One of the reasons for the entire grid of holes on my 4' x 8' assembly table is fixturing and squaring.
The last couple of days have been spent on this cornice job, for want of a better term. It goes above a bunch of windows/doors, but not against the ceiling like a crown moulding. I'm not completely done, there is still another return on the other end.
The main length is just under 44' (526.25") It returns to the floor on one end and makes a 90 degree turn on the other end for 17' (206"). The sheer size of it gets lost on the floor of a big shop though. It's 11" across each way with coped corners, but I forgot to take a pick of it while it was apart. I get some tomorrow on the other section.
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1400
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)
TS75
Shaper Origin/Workstation

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline afish

  • Posts: 741
Re: Huge cornice
« Reply #1 on: November 17, 2021, 08:03 PM »
One of the reasons for the entire grid of holes on my 4' x 8' assembly table is fixturing and squaring.

yes, its all I use it for really.  Nice work too, brings back memories to the old shop days.

Offline Steve1

  • Posts: 119
Re: Huge cornice
« Reply #2 on: November 18, 2021, 07:27 AM »
Nice.
I hope to see a photo after install.

Offline Crazyraceguy

  • Posts: 831
Re: Huge cornice
« Reply #3 on: November 18, 2021, 06:01 PM »
Nice.
I hope to see a photo after install.

This one I will for sure. It is going into a car dealership, so even if I can't get one from the installers, I can do it myself because it will be open to the public.

Parts all sitting ready for shipping on Monday.
« Last Edit: November 18, 2021, 06:05 PM by Crazyraceguy »
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1400
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)
TS75
Shaper Origin/Workstation