Author Topic: ? How to Make Yarn Rack  (Read 763 times)

0 Members and 1 Guest are viewing this topic.

Offline Mike Goetzke

  • Posts: 748
? How to Make Yarn Rack
« on: September 18, 2019, 03:04 PM »
My wife wants me to make one of these:

From this photo I see one diagonal is long solid board whereas the other is short segmented. Think I have seen for similar design where a slot is cut through 1/2 the width of the boards

Any help on how to make it appreciated.


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline waho6o9

  • Posts: 1601
    • Garage Door
Re: ? How to Make Yarn Rack
« Reply #1 on: September 18, 2019, 04:47 PM »
Practice on some scraps and when you get it the rest is a piece of cake.

Offline Michael Kellough

  • Posts: 5265
Re: ? How to Make Yarn Rack
« Reply #2 on: September 18, 2019, 05:10 PM »
All the diagonal interior boards are notches halfway through. Good project for an HKC or TS saw with a rail square.

Offline Bob D.

  • Posts: 2187
Re: ? How to Make Yarn Rack
« Reply #3 on: September 19, 2019, 06:07 AM »
Are you planning on something the same size as what you show in the photo.

Hard to tell but that one looks to be made from 2x and 1x material 6 or 8 inches wide.

I think if you look closer at the photo you'll see that the board are notched as evidenced
at this one intersection in the upper left of your photo.
It's a table saw, do you know where your fingers are?