Author Topic: H&K Custom Barn Doors  (Read 114876 times)

0 Members and 1 Guest are viewing this topic.

Offline TXFIVEO

  • Posts: 539
Re: H&K Custom Barn Doors
« Reply #480 on: September 11, 2021, 07:27 PM »
9-1/2’ tall by 5’ wide arrow door with hidden sliding hardware installed…sleek setup!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Michael Kellough

  • Posts: 5274
Re: H&K Custom Barn Doors
« Reply #481 on: September 12, 2021, 09:17 AM »
I don’t get the sliding door craze but this door’s hidden hardware is intriguing.
Also, how you managed to make and keep such a large panel so flat!

Looks like you’re very busy but if you have time to post some “behind the curtain” pics I bet I’m not the only one who would appreciate them.

Offline TXFIVEO

  • Posts: 539
Re: H&K Custom Barn Doors
« Reply #482 on: September 13, 2021, 08:29 PM »
Second shaker style door built and installed using the hidden hardware setup in Argyle, TX…

Offline TXFIVEO

  • Posts: 539
Re: H&K Custom Barn Doors
« Reply #483 on: Yesterday at 10:07 PM »
Tall Flemish glass doors built and ready for installation….