Author Topic: Hall Table  (Read 511 times)

0 Members and 1 Guest are viewing this topic.

Offline CeeJay

  • Posts: 79
Hall Table
« on: May 16, 2020, 09:05 AM »
Here’s my latest effort. A Tasmanian Blackwood and European Beech hall table.

After milling up the stock to dimension with the machinery it’s mostly hand made, I used the DF500 to set the drawer rails into the frame but otherwise hand cut mortise and tenons and dovetails.

I’m pleased with how the Blackwood inlays have worked out on the legs, and below the rails, and the depth of the shadow line below the top.

Lots of mistakes made along the way but as usual if you don’t know they are there they are hard to see!!

Anyway every project is a learning experience.
















Sent from my iPhone using Tapatalk

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline RJNeal

  • Posts: 473
Re: Hall Table
« Reply #1 on: May 16, 2020, 09:34 AM »
Nice work.
I like the contrast.
Have you walked your saw today?

Offline Sparktrician

  • Posts: 3930
Re: Hall Table
« Reply #2 on: May 16, 2020, 09:39 AM »
Really nice job!!!   [smile]
- Willy -

 "Remember, a chip on the shoulder is a sure sign of wood higher up." - Brigham Young

Offline mrFinpgh

  • Posts: 387
Re: Hall Table
« Reply #3 on: May 16, 2020, 11:14 AM »
great job..  looks excellent.

Offline David

  • Posts: 435
  • Author/speaker/advisor to entrepreneurial experts.
    • A few pieces that I’ve built
Re: Hall Table
« Reply #4 on: May 16, 2020, 01:44 PM »
I am really impressed with that. Esp the design. That shot you took of the corner, and three ankles, really shows it off. Kudos to you.
Fifth book (less interesting than woodworking) at http://www.expertise.is

Offline CeeJay

  • Posts: 79
Re: Hall Table
« Reply #5 on: May 16, 2020, 05:55 PM »
Thanks all. David I put about 75 hours into this - about half that on the drawer- so really appreciate the feedback.

This was as much an exercise in learning and trying out new techniques as a table build.

I hadn’t done a hand cut dovetail drawer, inlays or tapered legs before so took a lot of time on it.

Thought for a long while about the shadow line, plus tried out several handle designs!




Sent from my iPad using Tapatalk

Offline JimD

  • Posts: 443
Re: Hall Table
« Reply #6 on: May 16, 2020, 06:54 PM »
Looks great!

Offline CeeJay

  • Posts: 79
Re: Hall Table
« Reply #7 on: May 16, 2020, 06:54 PM »







Sent from my iPhone using Tapatalk