Author Topic: Gave the DF500 a bit of a workout today.  (Read 434 times)

0 Members and 1 Guest are viewing this topic.

Offline Crazyraceguy

  • Posts: 1578
Gave the DF500 a bit of a workout today.
« on: June 08, 2022, 06:51 PM »
Double 8mm tenons for these 2" frames. There are 16 units that are 45" high and 66" wide, that's 256 plunges, plus an extra piece of each side. They are the mounting spacer for the other frames that cover the TV in some areas. The DF500 ran pretty much continuously for over an hour, not even warm.
This is part of the same job as the radius corner desks that I have been working on. You can actually see the parts for the next one in the left side of the background.
CSX
DF500 + assortment set
PS420 + Base kit
OF1010
OF1010F
OF1400
MFK700 (2)
TS55, FS1080, FS1400 holey, FS1900, FS3000
CT26E + Workshop cleaning set
RO90
RO125
ETS EC 125
RAS115
ETS 125 (2)
TS75
Shaper Origin/Workstation
MFT clamps set

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline ChuckS

  • Posts: 3594
Re: Gave the DF500 a bit of a workout today.
« Reply #1 on: June 08, 2022, 07:14 PM »
If there were only two tools that I could bring to an island...the SawStop (the island doesn't have an ER [tongue]) and DF500 would be a no brainer for me.
« Last Edit: June 08, 2022, 07:35 PM by ChuckS »