Author Topic: Fixing Senna Siamea table top  (Read 607 times)

0 Members and 1 Guest are viewing this topic.

Offline Mike35x95x1

  • Posts: 67
Fixing Senna Siamea table top
« on: November 29, 2020, 07:14 AM »
Hi,

I am working now on new table top. It is my first experience with Senna Siamea. Except standard knots and cracks there is shallow dimple in the wood (80x60x2) and would like to get some hints how to fix it.

I have no thickness planer so I am looking for some alternatives.

I have epox G800. Do you think it’s a good idea to fill it?





Thanks
Mike


DIYer from Europe (TS55, KS60, DF500, OF1010, FS1400, FS-WA/90, FS-PA-VL)

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline DOUG M

  • Posts: 10
Re: Fixing Senna Siamea table top
« Reply #1 on: November 29, 2020, 12:07 PM »
Not sure with that type of wood you have,  But I have used a wet rag and a iron and was able to raise the wood on a project I had. Just a suggestion. Good luck.