Author Topic: Expandable height adjustment on C-Table ?  (Read 640 times)

0 Members and 1 Guest are viewing this topic.

Offline Intex

  • Posts: 163
Expandable height adjustment on C-Table ?
« on: December 01, 2019, 12:33 PM »
After finishing a C-Shaped end table, I must have taken too many cuts, since the vertical piece came out 1.5" too short, and if I use the table to slide under a taller chair, it is about 5" too short. Has anyone tried to cut a VERTICAL MEMBER in half, then extend it using two S/Steel flat stock pieces imbedded into the bottom half, and running loose in slots in the top half? I can either route grooves, insert the steel shafts, then cover with another wood cap or make new ones with a sandwich of 3/8" oak, then spacers to fit the flate stock, then another 3/8" full size cap piece.

I want to use the tables (3) as work tables or dinner tables while Im watching TV on favorite chairs, but the favs both have arms at different ieights.

See attached sketch

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.