Author Topic: Copper and White Oak Veneer Bar  (Read 2858 times)

0 Members and 1 Guest are viewing this topic.

Offline Kevin Johnson

  • Posts: 93
Copper and White Oak Veneer Bar
« on: May 30, 2008, 04:52 PM »
Here are some pictures of a bar that I made.  The top is an inlay of copper and white oak over a MDF substrate.  Its design was inspired by the beautiful work that Per does (thanks! :)).  I used the TS 55 to cut all the panel and the veneer for the inlays.  I used the 1400 router to square off the inlays as well as route the substrate for the wood inlays.  I had to route them out because the copper was thinner than the wood veneer.  All sanding was done with Festool sanders.

8560-0
8562-1
8564-2

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Kevin Johnson

  • Posts: 93
Re: Copper and White Oak Veneer Bar
« Reply #1 on: May 30, 2008, 04:53 PM »
More pictures...
8566-0
8568-1
8570-2
8572-3
8574-4
« Last Edit: May 30, 2008, 04:56 PM by Kevin Johnson »

Offline ambob

  • Posts: 12
Re: Copper and White Oak Veneer Bar
« Reply #2 on: May 31, 2008, 04:00 AM »
nice!i want topost it to china woodwork fourm,ok?

Offline Kevin Johnson

  • Posts: 93
Re: Copper and White Oak Veneer Bar
« Reply #3 on: May 31, 2008, 06:09 AM »
Thanks, sure go ahead and post it.

Offline Robert Robinson

  • Posts: 722
  • southern Indiana, U.S.A.
Re: Copper and White Oak Veneer Bar
« Reply #4 on: May 31, 2008, 09:35 AM »
That is nice. I want to have a drink! I like the use of the copper, and that Per inspired you. I have a friend that has wanted me to help him build a bar, he has been talking about it for almost a year now, but I recently seen Per's work, I was going to show him how good looking it could be if I had some skills.  ;D
TS-55, FS-KS angle unit, 55 inch guide rail, Domino (pin style), 3 Domino systainer assortments(one sipo set),Multi-position Guide Stop 20, Domiplate , PSB-300, FOGtainer 4, CXS set