Author Topic: CNC'd Vario inspired bench top  (Read 927 times)

0 Members and 1 Guest are viewing this topic.

Offline fritter63

  • Retailer
  • *
  • Posts: 1433
CNC'd Vario inspired bench top
« on: February 13, 2021, 08:11 PM »
Just finished CNCing a Vario inspired 36" x 72" "holy" worktop.

Used the Festool LR32 20mm boring bit, which was a mistake. It tended to burn in the MDF (I think I just didn't slow it down enough) and it tore out on the bottom side of the plywood. Next time I'll just interpolate the holes with a smaller CNC bit.

Otherwise it came out very nice. Slot for removable filler strip on the 90 degree cut line.

327703-0

327705-1

327707-2

327709-3

327711-4

327713-5

327715-6

327717-7

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Mario Turcot

  • Posts: 1288
Re: CNC'd Vario inspired bench top
« Reply #1 on: February 17, 2021, 01:00 AM »
Very interesting top. When are you going to show it in action?  [drooling]
Mario

Offline fritter63

  • Retailer
  • *
  • Posts: 1433
Re: CNC'd Vario inspired bench top
« Reply #2 on: February 22, 2021, 06:52 PM »
Very interesting top. When are you going to show it in action?  [drooling]

Well, it's the hands of my friend now, who I made it for, but here is the original in action!


Offline Mario Turcot

  • Posts: 1288
Re: CNC'd Vario inspired bench top
« Reply #3 on: February 22, 2021, 06:55 PM »
Wow very nice.
Mario